no power from carel retro fit
3 posts
• Page 1 of 1
no power from carel retro fit
by robert edmunds » Mon Jan 11, 2010 5:00 pm
"I installed a new BD-50 along with a control module yesterday, the carel thermostat powered up and was showing evaperator temperature. However I was getting no signal to the module. During programming I did not get ST 1 symbol. The symbol shgowed ( S then a character that looks like an upside down F 1. Is this the symbol or is it in error? any other suggestions as to why the thermostat is not communicating with the module."
- robert edmunds
- Posts: 0
- Joined: Thu Jul 08, 2010 5:00 pm
Re: no power from carel retro fit
by Forum Tech » Mon Jan 11, 2010 5:00 pm
"Robert,The "T" is displayed in lowercase on the Carel display, it looks like an upside down "F". We will correct the manual so "ST" is shown as "St". Sorry about the confusion.Forum Tech"
- Forum Tech
- Posts: 12
- Joined: Wed Jan 21, 2009 5:00 pm
Re: no power from carel retro fit
by robert edmunds » Mon Jan 11, 2010 5:00 pm
"thanks for the reply, if thats the case, I programmed it correctly, but still have no signal to the module. what do you suggest?"
- robert edmunds
- Posts: 0
- Joined: Thu Jul 08, 2010 5:00 pm
3 posts
• Page 1 of 1
Return to RPARTS DIY Kits Forum
Who is online
Users browsing this forum: No registered users and 1 guest